|
New Page 1
X-10 PHRO4 2 Channel Keychain Remote
Turn your house lights on and off from the safety of your car!
X10's powerful, sleek and thin design is exactly what our
customers have asked for!
It has dual on/off buttons to remotely control your X10
Lamp Modules, Appliance Modules, and Wall Switch Modules.
It even has the ability to dim and brighten your lights,
even if they didn't before
The PHR04 Wireless RF Keychain Remote works with the X-10 PRO Base
Transceiver (PAT01) or any
X-10 PRO Security Base (PRO2000) to let you turn on/off two sequentially
coded X-10 PRO Modules and
brighten/dim lights connected to Lamp Modules and Wall Switch Modules.
Setting up the Remote:
In the default state (after first fitting the battery) the PHR04 is set to
Housecode A. The first (top) two
ON-OFF buttons control modules set to Unit Code 1. The second (middle) two
buttons control A2.
1. Plug in an X-10 PRO Transceiver (PAT01 or Security Console, sold
separately).
2. To turn on or off X-10 PRO Modules set to Unit Code 1 (on Housecode A)
press the first (top) ON
or OFF button. To turn on or off X-10 Modules set to Unit Code 2 (on
Housecode A) press the second
(bottom) ON or OFF button. To brighten or dim Lamp Modules or Wall Switch
Modules press the
number button first, then press Bright or Dim button. If you want to
control Modules 1 and 2 on
Housecode A.
To change the Housecode:
• Press and hold the first (top) ON button. The red LED blinks once. 3
seconds later, the LED blinks the
current setting: 1 blink for Housecode A, 2 blinks for B..... 16 blinks
for P.
• Release the first (top) ON
button.
• Press and release the first (top) ON button the appropriate number of
times for the Housecode you
want to set. Once for A, twice for B, etc. The LED blinks for each press.
IMPORTANT: Hold the button
on your last press. 3 seconds later, the red LED blinks back the new
setting, (i.e. 3 blinks for Housecode
C). If you do not follow this programming sequence, the LED will stay on
for 1 second and your existing
setting will not be changed.
To change the Unit Code for the first (top) two buttons (the second pair of buttons are always
one Unit Code # higher than the first pair, i.e. if you set the first
button to 6, the second button controls
7, etc.).
• Press and hold the top OFF
button. The red LED blinks once. 3 seconds later,
the LED blinks the current
setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16.
• Release the top OFF button.
• Press and release the top OFF
button the appropriate number of times for the Unit
Code you want.
IMPORTANT: Hold the button on your last press. 3 seconds later new code
blinks back. If you do not
follow this programming sequence, the LED will stay on for 1 second and
your existing setting will
not be changed.
To change the battery: Pry the unit
apart and fit a CR2025 Lithium 3V battery. Observe polarity.
Note: As with all RF transmitter devices; electrical fields, metal doors
or door/window frames and appliances can
cause interference that can decrease the strength of the transmitted
signal. Re-orienting the transmitter or
receiver console may increase your ability to send and receive the
necessary signals.
|
