|
New Page 1
Ademco CIA Specific External Modem For Downloading Ademco-FBI-Apex Security Systems.
Used For Direct PC To Panel & Telco To Panel Programming Of:
Ademco Lynx
Vista 10 & 10P - 15 & 15P
Vista 20 & 20P & 20PS
Vista 30 & 32 FB
Vista 40
Vista 50 & 50P
Vista 128-128B-128BP-128FB
Vista 250 Series Panel
Installation
Instructions Or (See Below)
Direct Wire Download Connection Using A Modem
NOTE: IF Using A CIA (This) Modem, and Direct Wire Downloading Using The Cable
That Comes With This Modem, Simply Plug In The Phone End Of The Phone Wire That Came With
The Modem Into The TELCO Side Of The Modem.
2-Then You MUST Connect The RED&GREEN Alligator Clips To The Alarm Panel RED
&GREEN Telco Connection.
3-You Also Must Connect The Black Alligator Clip To Negative AUX Power, And The Yellow
Alligator Clip To Positive Aux Power.
4-If Trying to connect to an Ademco LYNX or LYNXREN Simply Use A 12 Volt Battery For Your
AUX Power Connection.
See Direct Wire Download Instructions Link Above.
What is the CIA?
The Communication Interface Adapter (CIA) supports communication between
ADEMCO Group products and the following downloading software:
ADEMCO Group Compass
· ADEMCO V-Link
· FBII EZ-Mate
· FBII Compass
· Apex Compass
Standards Supported
The CIA can be used on a standard two-wire dialup phone line and supports
the following standards:
· CCITT
V.22Bis
· V.22
· BELL
212
· BELL
103 (Supports any data rate from 1 Hz to 300 Hz.)
It also supports the standard AT command set used by the Hayes SmartModem
2400. The following diagrams show the front and back of the CIA.
What You Need
To install and operate the CIA, you need the following items.
· Compass, V-Link, or
EZ-Mate software allows you to set up and upload/download the control panel’s
programming information.
· Telephone Cable – The
CIA is designed to operate over a standard telephone line through its telephone cable
connection.
· Serial Cable – Use a
serial cable to connect the CIA to a computer. The serial cable requires a 25-pin male D
connector on one end and a connector appropriate for your computer on the other. The cable
should have a metal shield to reduce the possibility of radio frequency interference. The
following are the critical pins on the CIA connector.
How to Install a CIA
1. Connect to a phone outlet:
A. Plug one end of the telephone cable into the LINE connector of the CIA.
B. Plug the other end into the telephone wall jack.
C. If you use a telephone on the same line as the CIA, plug one end of the
telephone cable into your phone and
plug the other end to the PHONE connector of the CIA.
2. Connect to a computer:
A. Turn the CIA and computer off.
B. Plug the male end of the modem cable into the female connector marked
RS232 on the back of CIA and tighten
the screws.
C. Plug the other end of the cable into the serial port on the back of the
computer.
3. Connect to a power outlet:
A. Plug the power cable into the POWER connector.
B. Plug the 9V transformer into a wall outlet.
4. Power up the computer.
5. Run your downloading
software application. The first time you connect to the CIA, based on your downloading
software, you will need to specify which port on your computer is connected to the CIA.
Consult the Downloader User Manual for specifics.
|
