|
Ademco 998MX 50 X 50 Foot Multiplex PIR with Lookdown
- 50' x 50' coverage
- Built-in Remote Point Module
- Both DIP switch and serial number addressing
- EZ-Mount features for fast installation
- Includes additional long range and pet alley lenses
- Horizontal and vertical pattern adjustment
- Automatic temperature compensation
- Extremely low current
- Tamper
- 6 year over-the-counter warranty
It makes sense to use ADEMCO's 998MX multiplex motion detector. Not
only is it smarter than ever, but it provides the opportunity to reduce your overall
installation costs! Whether it's a commercial or residential installation, the 998MX
offers you the following benefits:
- Point ID identifies the exact location of the intruder with either a DIP Switch Address
or a Serial Number Address as distinctive as a fingerprint. And with the built-in Remote
Point Module, the cost is less than a separate module and sensor.
- ADEMCO's patented Global Polling technology senses alarms up to up to 8 times faster
than conventional multiplex.
- ADEMCO's unique 2-wire multiplex reduces installation costs over conventional 4-wire
hardwire and multiplex approaches:
-- Wire cost is reduced and less than half the number of connections are necessary
-- No more need to home run wiring
-- Each sensor draws super low current, reducing power & battery requirements on large
installations while allowing for longer wire runs or smaller gauge wire
PIR
Patterns | Ordering Information |
Detection Method
Coverage
- Standard Wide Angle Lens - 50' x 50' (15m x 15m), 90º
Long Range Lens - 100' x 10' (30m x 3m)
Pet Alley Lens (998 only) - 50' x 70' (15m x 21m), 100º
Detection Pattern
- Standard Lens: 18 zones (9 long range, 5 intermediate, and 4 short range)
- Long Range: 5 zones, (1 long range, 2 intermediate, 2 short range)
- Pet Alley: 12 zones Detector provides single "downward-looking" zone with all
lenses (downward-looking window must be masked when using pet alley lens)
Pulse Count
- Installer-selectable, 1-, 2-, 3-event
Detectable Walk Rate
- 0.5-5 ft/sec (0.15-1.5m/sec)
Mounting
Indicators
- Red LED with enable/disable switch
Input Voltage
- 8-11V peak to peak at polling loop terminals
Current
- 1 mA (LED disabled) 3 mA (alarm, LED enabled)
Standby
- Power source should be capable of at least 4 hours of battery standby
Operating Temp
- 14º to 122ºF (-10º to 50ºC)
Operating Humidity
- Up to 95% RH (max.), non-condensing
Dimensions
- 2-5/8" W x 4-3/8" H x 2" D
(67mm x 111mm x 51mm)
Accessories:
- 998SB: Swivel bracket for 998
PIR Patterns
Standard Lens |
Pet Alley Lens |
Long Range Lense |
 |
 |
 |
|
|
